Pug-7 Analog Radiation Detector, with external probe

  • Model: Pug-7

Starting at: $900.00

Please Choose:

P-15




P-6LB




P-28




PNS-19




PNS-20




PAS-8




PAS-9




Add to Cart:
Compatible with Geiger Mueller, NaI Scintillation, and Neutron probes, Choose one

This radiation detector weighs only 2.25 lbs. It will function well in most alpha, beta, neutron, X-ray or gamma monitoring programs. It is designed for the measurement and control of radiation contamination. This universal instrument can be used with a wide array of G-M detectors, NaI Scintillation Detectors, and Neutron Scintillation detectors.

The PUG-7 utilizes continuously adjustable regulated high voltage supply 1500V to interface with G-M, scintillation, gas proportional, BF3, or He3 detectors, delivering a one millivolt + pulse. An adjustable discriminator allows full control over system sensitivity. The pulse input is zener diode protected so that probes may be interchanged without shutting off instrument. The high voltage system provides sufficient output to operate Geiger Mueller tubes up to 3 inch diameter without a loss of efficiency as well as PM tubes with voltage dividers of over 100 mega-ohms total resistance. The meter face on the PUG-7 instrument reads out in CPM or optionally in Sieverts or CPS. Additionally, it is provided with a means for mR/hr cards matched to any Technical Associates P series probe. These cards are transparent and adhere to the meter face, thus contamination and radiation levels may be read simultaneously with a variety of probes.

The shell of the instrument is smoothly finished, attractive baked enamel over an aluminum case. The cover is machined, black anodized aluminum with white highly visible markings. The meter with a 3.5 inch scale length presents four ranges: 0-500; 5,000; 50,000; 500,000 counts per minute, with battery check marking.

Four Ranges (manual, analog)
Lightweight
Audio, Adjustable Speaker
Large 3.5 inch Meter Face
Compensation for coincidence

Specifications:

Indicators: Panel meter: 0-500 cpm (times range switch multiplier), 0-1,500 volts (0-2,500 V in PUG-7A and PUG-7E). Battery condition: Flashing Red LED and Audible Sonalert. Proportional to count rate.
Ranges: 0-500; 5,000; 50,000; 500,000 cpm (opt 0-5 cps) plus mR, uR or R/h (optionally SI units) overlay, depending on probe.
Probe Connector: BNC (optionally MHV) low noise Teflon insulated.
Battery: 9 volt transistor battery EverReady 1222 or equivalent (150-300 hours typical life).
Dimensions: 3-1/4'' H, 4-1/4'' W, 7-1/4'' long excluding probe holder and handle.
Weight: 2 lbs. 4 oz. Shipping weight 5 lbs.

This product was added to our catalog on Thursday 07 November, 2019.

Sponsors

Zen Cart the art of e-commerce

eStart Your Web Store with Zen Cart(R)

Have you seen ...

Zen Cart the art of e-commerce

Who's Online

There currently is 1 guest online.
Your IP Address is: 3.218.67.1
Copyright © 2020 Direct Scientific. Powered by Zen Cart
if you have to think ... you haven't been Zenned!